The article presents simulator of injection-ignition system of internal combustion engine with spark ignition developed at the Technical University of Opole. This system is based on Bosch series engine ECU with software 7.5. It allows to analyze of motor parameters using both on-board diagnostic system, and data network CAN BUS under different operating conditions of the system. For this purpose, the simulator is equipped with a number of additional devices enable to generate repetitive input signals for the ECU, allowing to open the actual working conditions. Crucial for the simulator was to generate the signals informing ECU about the instantaneous position of the crankshaft and camshaft. For this purpose, the module Arduino was used. This type of solution allows, to recreate momentary engine operating conditions. This article also presents the concept of development with new features and sentences feasible for this type of device and simulation mode.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren




    Hardware-in-the-loop simulation and testing of digital engine control system [5253-182]

    Cheng, T. / SPIE - The International Society for Optical Engineering | British Library Conference Proceedings | 2003



    Integration of Physical AMESim® Engine Model in Hardware in the Loop Environment, Dedicated to Engine Control Unit Testing

    Varoquié, Bertrand / Saussol, Landry / Bourdon, Thierry | SAE Technical Papers | 2007


    Hardware-in-the-Loop Testing of Engine Control Units - A Technical Survey

    Schuette, Herbert / Ploeger, Markus | SAE Technical Papers | 2007