The shape complexity of aerospace components is continuously increasing, which encourages researchers to further refine their manufacturing processes. Among such processes, blown powder direct laser deposition process is becoming an economical and energy efficient alternative to the conventional machining process. However, depending on their magnitudes, the distortion and residual stress generated during direct laser deposition process can affect the performance and geometric tolerances of manufactured components. This article reports an investigation carried out using the finite element analysis method to predict the distortion generated in an aero-engine component produced by the direct laser deposition process. The computation of the temperature induced during the direct laser deposition process and the corresponding distortion on the component was accomplished through a three-dimensional thermo-structural finite element analysis model. The model was validated against measured distortion values of the real component produced by direct laser deposition process using a Trumpf DMD505 CO2 laser. Various direct laser deposition fill patterns (orientation strategies/tool movement) were investigated in order to identify the best parameters that will result in minimum distortion.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Finite element modelling of substrate thermal distortion in direct laser additive manufacture of an aero-engine component


    Weitere Titelangaben:

    Finite-Elemente-Modellierung der thermischen Verzerrung des Substrats bei der Herstellung von Flugzeugmotorteilen durch direkte Laserabscheidung


    Beteiligte:
    Marimuthu, S. (Autor:in) / Clark, D. (Autor:in) / Allen, J. (Autor:in) / Kamara, A.M. (Autor:in) / Mativenga, P. (Autor:in) / Li, L. (Autor:in) / Scudamore, R. (Autor:in)


    Erscheinungsdatum :

    2013


    Format / Umfang :

    13 Seiten, 14 Bilder, 1 Tabelle, 43 Quellen




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    Flow distortion measurements in convoluted aero engine intakes

    Zachos, Pavlos / MacManus, David G. / Chiereghin, Nicola | AIAA | 2015


    Complex aero-engine intake ducts and dynamic distortion

    MacManus, David G. / Chiereghin, Nicola / Gil Prieto, Daniel et al. | AIAA | 2015


    Low Frequency Distortion in Civil Aero-engine Intake

    Carnevale, Mauro | Online Contents | 2017


    Low Frequency Distortion in Civil Aero-Engine Intake

    Carnevale, Mauro | Online Contents | 2016


    ECM in Aero Engine Component Machining

    Langdon, CJ | Emerald Group Publishing | 1985