It is very important to identify the top dead centre (T.D.C.) phase in the combusting analysis of I.C. engine. Erroneous determination of T.D.C. has been recognized as the major error source for thermodynamic cycle calculations, such as mean indicated pressure, heat release curves and so on. The methods of T.D.C. determination in the indicator diagram of the medium speed marine diesel engine is studied in this paper. Analyzing results indicate that T.D.C. can be determined by detecting the piston displacement directly with an electric-capacity or microwave transducer. This method is more accurate but more additional cost and mounting problem. To use non-fired cylinder pressure maximum point adds T.L.A. - thermodynamic loss angle - is more applicable for the medium speed marine diesel engine. And the key problem of the later method is T.L.A. determination. In this paper, the effect factors of T.L.A. are analyzed. An ideal polytropic exponent curve are introduced and compared with the real polytropic exponent curve to estimate T.L.A and the program is compiled. T.L.A. of a certain diesel engine is calculated and its T.D.C. phase is identified. Comparing the calculated T.L.A. with the tested T.L.A. in experiments, which proves that this method is feasible and the result is correct. It supplies a gap about the study of the T.D.C determination for the medium speed marine diesel engine.
Experimental Study on the Method for T.D.C. Determination of a Medium Speed Marine Diesel Engine
2013
6 Seiten, 5 Bilder, 2 Tabellen, 7 Quellen
Aufsatz (Konferenz)
Englisch
High-speed marine diesel engine
Engineering Index Backfile | 1932
|High-speed marine diesel engine
Engineering Index Backfile | 1932
|Combustion development of new medium-speed marine diesel engine
Kraftfahrwesen | 2013
|Development of the new medium speed marine diesel engine CS21
Kraftfahrwesen | 2013
|