In the paper, a lightweight design method for tailor-welded blanks (TWBs), termed as Topology Tailoring Method (TTM), is proposed, which is based on topology optimization philosophy and in which the variable density method is employed so as to reach the goal of the smallest structure strain energy. By using this method, a TWB autodoor subjected to a specific working condition is topologically optimized in HyperWorks, thus obtaining the more lightweight autodoor. At last, a side impact simulation of the autodoor is demonstrated, thus showing the effectiveness of the method.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Topology Tailoring Method of TWB Autobody Parts Based on HyperWorks


    Beteiligte:
    Xu, An-Ping (Autor:in) / Liu, Y.S. (Autor:in) / Wang, H. (Autor:in) / Liu, Y. (Autor:in) / Fu, Y.N. (Autor:in)


    Erscheinungsdatum :

    2011


    Format / Umfang :

    5 Seiten




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Optimization of deep drawing of autobody parts

    Teterin, G.P. / Verchov, E.Y. | Tema Archiv | 1987


    Optimization of deep drawing of autobody parts

    Teterin, G.P. / Khov, E.Y. | Tema Archiv | 1987


    Application of vibration damping steel sheet for autobody structural parts

    Suzukawa,Y. / Ikeda,K. / Morita,J. et al. | Kraftfahrwesen | 1992


    Dynamic denting of autobody panels

    Burley,C.E. / Niemeier,B.A. / Koch,G.P. et al. | Kraftfahrwesen | 1976


    Galling behaviour and its tests in press forming of autobody parts

    Miyauchi, K. / Furubayashi, T. / Herai, T. et al. | Tema Archiv | 1978