A novel miniaturized piezoelectric wind flutter generator is proposed which consisted of a flexible beam and a PZT cantilever. The working principle is based on flexible beam flutter, which can amplify the PZT cantilever vibration. A prototype was tested in a wind tunnel. It is found that there are three behavior states with wind speed increasing, and flutter behavior takes place when wind speed varies between the critical wind speed Uc1 and Uc2, an empirical formula was obtained about the critical speed Uc1. The open circuit voltage and power were measured. The device can generate 794 µW output power with 30 kΩ resistor in a wind of speed 20m/s, power density is 139 µW/cm3.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A Miniaturized Piezoelectric Wind Flutter Generator


    Beteiligte:
    Zhao, Xing-Qiang (Autor:in) / Wen, Zhi-Yu (Autor:in) / Du, Zhi-Gang (Autor:in)


    Erscheinungsdatum :

    2012


    Format / Umfang :

    4 Seiten




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Flutter Suppression Using V-Stack Piezoelectric Actuator

    Ardelean, Emil / McEver, Mark / Cole, D. et al. | AIAA | 2003


    Flutter Suppression Using V-Stack Piezoelectric Actuator

    Ardelean, E. / McEver, M. / Clark, R. et al. | British Library Conference Proceedings | 2003


    Control of structural flutter using piezoelectric patches

    Hariri, M. / John, S. / Trivallo, P. | Tema Archiv | 2009


    FLUTTER WIND TUNNEL TEST MODEL AND METHOD OF PRODUCING FLUTTER WIND TUNNEL TEST MODEL

    AOKI KAZUYUKI | Europäisches Patentamt | 2023

    Freier Zugriff

    FLUTTER WIND TUNNEL TEST MODEL AND METHOD OF PRODUCING FLUTTER WIND TUNNEL TEST MODEL

    AOKI KAZUYUKI | Europäisches Patentamt | 2023

    Freier Zugriff