A rising number of modern automobiles are equipped with long-, mid- or short-range radar distance sensors. Especially long-range radar based driving assistance systems operating at 77 GHz get more and more into focus to enhance traffic safety. Especially for these long range modules the adjustment of the sensors exactly in parallel to the thrust vector of the vehicle has to be done in an extremely small range of tolerances. If the misalignment angle exceeds ± 0.5° objects outside the lane at maximum detection distance will be misinterpreted as being an obstacle inside the own lane. Up to now the radar beam alignment is only conducted during the vehicle's assembly in the factory. In the automobile workshops there is no possibility to measure the radiated beam. All alignment tools are based on adjusting the radar sensor housing by optical or other methods and rely on the exact alignment of the radar beam with respect to its module housing. The achieved tolerances of such tools are quite high and cannot be verified. In this contribution a new method for aligning the radar module by directly measuring the microwave beam is presented. The system is based on the six-port concept that is known since mid of the 1960s for phase measurements with extremely high accuracy. The microwave beam is received by two antennas resulting in a phase difference between their signals depending on the path difference. By superimposing the two anten na signals to each other with four different relative phase shifts this path delay can be evaluated. The path delay is a direct measure of the angle-of- arrival of the radar beam at the antenna plane. As the delay evaluation is done before downconverting the signal to baseband, the accuracy of the system is extremely high. By placing the six-port setup in front of a car its radar beam alignment can be evaluated with a resolution of 0.05° even without any filtering and post processing of the measured data. The angle resolution can be further increased by this post processing. Ademonstrator circuit of the complete analog (microwave and baseband) sensor module will be shown and measurement results for a 24 GHz automotive radar system will pe presented. As the six-port concept is a universal wireless sensor for angle-of-arrival measurements, its application is not limited to automotive radar module alignment. It can be a useful tool for any phase difference measurement problem.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    C1.1 A new concept for aligning automotive long-range radar modules based on wireless microwave sensing


    Beteiligte:
    Weigel, Robert (Autor:in) / Vinci, Gabor (Autor:in) / Laemmle, Benjamin (Autor:in) / Koelpin, Alexander (Autor:in)


    Erscheinungsdatum :

    2011


    Format / Umfang :

    4 Seiten, 5 Bilder, 6 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Automotive applications of microwave radar

    Tribe, R. | Tema Archiv | 1993


    Long-range human body sensing modules with electric field sensor

    Togura,T. / Nakamura,Y. / Akashi,K. et al. | Kraftfahrwesen | 2008


    Long-Range Human Body Sensing Modules with Electric Field Sensor

    Akashi, Kazuya / Togura, Takeshi / Nakamura, Yasushi | SAE Technical Papers | 2008


    Simulation of Automotive Radar Sensors Extended to 77 GHz Long Range Detection

    Kedzia, Jean-Claude / Strand, Bo / Abenius, Erik | Tema Archiv | 2014


    Multi-Range Joint Automotive Radar and Communication using Pilot-based OFDM Radar

    Wang, Chang-Heng / Altintas, Onur / Ozkaptan, Ceyhun D. et al. | IEEE | 2020