With the increased use of larger-sized coiled tubing (CT), demand for CT tools is pushing the limits of tool rating and frequently extending the sizes required for jointed tubing operations. This paper describes a high-pressure, high-temperature (HPHT) motorhead designed for larger-sized CT and/or jointed pipe. Motorheads are used for well control, emergencyrelease disconnects, enabling circulation to the annulus, and establishing circulation to the annulus should the normal circulation path become plugged. The development and design of the new motorhead will be described, including its special mechanical capabilities that depended on careful alloy and elastomer selection. For example, the flapper valves can withstand 20,000-psi differential pressures in -40 to 400 deg F temperature cycles (from cold-hot-cold) in a single run. The flappers were designed to close in slam-shut situations without compromising well control, and the hydraulic disconnect can bear higher torque and tensile loads than any similar tool currently available. The completion fluid in combination with the well fluids presented problems for conventional sealing compounds exposed to pressure and temperature extremes. Results from a two-month testing period are discussed, which included pressure, temperature, tensile strength, torque, and fluid compatibility tests. FEA and CFD analyses were used to simulate flow, pressure, and slam shut conditions, enabling the most effective motorhead design for HPHT environments. A North Sea case history of a successful well intervention using the new motorhead is also described. Three fully certified traceable HPHT motorhead assemblies were used for six runs over a combined 121 days in wellhead pressures up to 10,800 psi and downhole temperature of 365 deg F. The tool was tested and serviced between runs. Under these rigorous conditions, it was critical that the valves held backpressure and retained their integrity after continuous pumping under high pressures and temperatures-these objectives were achieved.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    HP/HT compact motorhead for larger-OD coiled-tubing/jointed pipe operations: Design, testing, and successful case history


    Weitere Titelangaben:

    Ein Hochdruck-Hochtemperatur-Motorkopf für Betriebe mit Wickelrohren größeren Außendurchmessers: Auslegung, Test und Fallbeispiel


    Beteiligte:
    Ehtesham, Asif (Autor:in) / Hriscu, Joseph (Autor:in) / Howard, Robert (Autor:in)


    Erscheinungsdatum :

    2008


    Format / Umfang :

    11 Seiten



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Work platform for coiled-tubing downhole operations

    LEDET CLEMENT | Europäisches Patentamt | 2018

    Freier Zugriff

    WORK PLATFORM FOR COILED-TUBING DOWNHOLE OPERATIONS

    LEDET CLEMENT | Europäisches Patentamt | 2018

    Freier Zugriff

    COILED TUBING

    SAE Technical Papers | 1960


    Coiled tubing trailer

    LU MIKE XIAOLEI / WELK JOSEPH | Europäisches Patentamt | 2023

    Freier Zugriff

    COILED TUBING TRAILER

    LU MIKE XIAOLEI / WELK JOSEPH | Europäisches Patentamt | 2022

    Freier Zugriff