This study consists of two stages. In the first stage, bronze-based break linings were produced and friction-wear properties of them were investigated. In the second stage, 0.5%, 1%, 2% and 4% alumina (Al2 O3) powders were added to the bronze-based powders and Al2O 3 reinforced bronze-based break linings were produced. Friction-wear properties of the Al2O3 reinforced samples were aslo investigated and compared to those of plain bronze-based ones. For this purpose, friction coefficient and wear behaviour of the samples were tested on the grey cast iron disc. The hardness and density of the samples were also determined. Microstructures of the samples before and after the sintering and the worn surfaces of the wear specimens were examined using a scanning electron microscope (SEM). The sample compacted at 350 MPa and sintered at 820 degree C exhibited the optimum friction-wear behaviour. With increase in friction surface temperature, a reduction in the friction coefficient of the samples was observed. The lowest reduction in the friction coefficient with increasing temperature was for the 2% and 4% Al2 O3 reinforced samples. The SEM images of the sample indicated that increase in Al2O3 content resulted in adhesive wear. With increase in Al2O3 content, a reduction in mass loss of the samples was also observed. Overall, the samples reinforced with 2% and 4% Al2O3 exhibited the best results.
The effect of Al2O3 on the friction performance of automotive brake friction materials
Tribology International ; 40 , 7 ; 1161-1169
2007
9 Seiten, 31 Quellen
Aufsatz (Zeitschrift)
Englisch
Review of automotive brake friction materials
Kraftfahrwesen | 2004
|Review of automotive brake friction materials
Online Contents | 2004
|Review of automotive brake friction materials
SAGE Publications | 2004
|The Role of Copper on the Friction and Wear Performance of Automotive Brake Friction Materials
SAE Technical Papers | 2011
|The Role of Copper on the Friction and Wear Performance of Automotive Brake Friction Materials
British Library Conference Proceedings | 2011
|