The growing use of 3D die design in the American company 'Accurate DieDesign' has resulted in highly accurate tooling delivered on a timely basis without excessive and costly tryouts or time-consuming redrafts. The present article outlines the advantages of 3D over 2D die design. As the first step in creating a 3D design the usability of the imported model has to be determined. With a bent part, in most cases the imported model is all one need. With a stamped part, sometimes the part must be recreated using the original as a guide. Another important initial step when designing a die for a stamped part is to run the part through formability-analysis software to predict problems in forming the part. The next step involves creating a solid model of the strip to minimize or eliminate design changes that normally occur downstream when designing in 2D. An example of an 80-inch-long, 13-station progressive die that was modeled in Solid-Works along with Logopress3 die-design software is given. The die is used by a supplier of automotive stamped components.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Die Design goes full bore into another dimension


    Beteiligte:

    Erschienen in:

    Metal Forming ; 39 , 6 ; 70-73


    Erscheinungsdatum :

    2005


    Format / Umfang :

    4 Seiten, 3 Bilder



    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch