This study aims to provide an understanding of the factors that control weld metal strength and toughness of mechanized field girth welds produced in X80 and X100 line pipe steels using a range of pipeline gas metal arc welding procedures. In the investigation of X80 welds, a series of experimental single and dual torch gas metal arc welds were prepared with three C-Mn-Si wires, which contained additions of Ti, Ni-Ti and Ni-Mo-Ti. The weld metal microstructures, tensile properties, notch toughness, and fracture resistance were evaluated. The results indicate that high weld metal yield strength and good toughness can be achieved. The X80 single torch welds exhibited higher yield strength but lower toughness compared to the corresponding dual torch welds. For the development and evaluation of welding procedures for mainline girth welding of X100 pipe, two narrow gap mechanized gas metal arc welding procedures were evaluated with emphasis placed on measurement of the tensile properties. The results show that dramatically different properties (strength and toughness) can be found as a result of differences in energy input, interpass temperature and weld width or offset distance. Additionally, the preliminary tensile testing, which utilized both standard round bar and modified strip tensile specimens, illustrates the potential variation that can occur when assessing all-weld-metal tensile properties of narrow gap pipeline girth welds.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Structure and properties of X80 and X100 pipeline girth welds


    Beteiligte:
    Gianetto, J.A. (Autor:in) / Bowker, J.T. (Autor:in) / Dorling, D.V. (Autor:in) / Horsley, D. (Autor:in)


    Erscheinungsdatum :

    2004


    Format / Umfang :

    13 Seiten, 16 Quellen


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Assessment of properties and microstructure of X100 pipeline girth welds

    Gianetto, J.A. / Bowker, J.T. / Dorling, D.V. | Tema Archiv | 2005


    Girth welding of X100 pipeline steels

    Hudson, M.G. / Blackman, S.A. / Hammond, J. et al. | Tema Archiv | 2002


    X100 - girth welding, joint properties and defect tolerances

    Hudson, Mark / Vito, Luigi Di / Demofonti, Guiseppe et al. | Tema Archiv | 2005


    Defect tolerance in pipeline girth welds

    Hopkins, P. / Jones, D.G. / Fearnehough, G.D. | Tema Archiv | 1984


    Tensile and toughness properties of pipeline girth welds

    Gianetto, J.A. / Bowker, J.T. / Bouchard, R. et al. | Tema Archiv | 2007