The traditional approach to pipelines design is to select a wall thickness that maintains the hoop stress below the yield strength multiplied by a safety factor. The main design condition implied by this approach is yielding (and by extension burst) of the defect-free pipe. Failure statistics show that this failure mode is virtually impossible as the majority of failures occur due to equipment impact and various types of defects such as corrosion and cracks. Recent investigations show that these failure causes are much more sensitive to wall thickness than to steel grade. As a consequence, current design methods produce variable levels of safety for different pipelines - small-diameter, low-pressure pipelines for example have been shown to have higher failure risks due to mechanical damage than large-diameter, high-pressure pipelines. In addition, the current design approach has been shown to have limited ability to deal with new design parameters, such high steel grades, and unique loading conditions such as frost heave and thaw settlement. The paper shows how these limitations can be addressed by adopting a reliability-based limit states design approach. In this approach, a pipeline is designed to maintain a specified reliability level with respect to its actual expected failure mechanisms (known as limit states). Implementation involves identifying all relevant limit states, selecting target reliability levels that take into account the severity of the failure consequences, and developing a set of design conditions that meet the target reliability levels. The advantages of this approach include lower overall cost for the same safety level, more consistent safety across the range of design parameters, and a built-in ability to address new design situations. Obstacles to its application for onshore pipelines include lack of familiarity with reliability-based approaches and their benefits and lack of consensus on how to define reliability targets. The paper gives an overview of the reliability-based design approach and demonstrates its application using an example involving design for mechanical damage.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Reliability-based limit states design for onshore pipelines


    Beteiligte:
    Nessim, M. (Autor:in) / Zimmerman, T. (Autor:in) / Glover, A. (Autor:in) / McLamb, M. (Autor:in) / Rothwell, B. (Autor:in) / Zhou Joe (Autor:in)


    Erscheinungsdatum :

    2002


    Format / Umfang :

    13 Seiten, 25 Quellen


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Target reliability levels for design and assessment of onshore natural gas pipelines

    Nessim, Maher / Zhou, Wenxing / Zhou, Joe et al. | Tema Archiv | 2009


    Optimal design of onshore natural gas pipelines

    Zhou, Wenxing / Nessim, Maher A. | Tema Archiv | 2011


    Target reliability levels for design and assessment of onshore natural gas pipelines

    Nessim, Maher / Zhou, Wenxing / Zhou, Joe et al. | Tema Archiv | 2004


    Application of high-grade steels to onshore natural gas pipelines using reliability-based design method

    Zhou, Joe / Rothwell, Brian / Zhou, Wenxing et al. | Tema Archiv | 2007