Today's car designers ask for compact and light-weighted headlamps with several new functional features and special stylistic elements. This yields in new lighting technology such as modern free form and ellipsoid module reflectors with small dimensions and the need to use highly sophisticated Materials. Both of this is sensitive to the amount of temperature and at a critical level may cause irreversible damage. Therefore, it is necessary to predict temperature loads at an early development stage in order to ensure new headlamp concepts and to shorten development time. An approach to calculate and analyze temperatures in headlamps by continuum fluid dynamic methods (CFD) is presented which can be compared and correlated to measurements carried out with infrared thermography and demonstrates the benefit of this method. In this paper a temperature simulation of the AUDI A2 ECE headlamp is shown. First, temperature measurements are described to generate temperature values which can be used to compare the simulation results with reality. Temperature measurement is performed by touching method or contact method with 4 thermo-elements (NiCr/Ni) or with resistance thermo elements (Pt 100). Thermographic devices make it possible to get the temperature distribution of a whole surface, especially the position of the highest temperature points (,hot spots'). To perform a sophisticated simulation of the temperature loads in headlamps it is necessary to find a physical representation of the system. This is done by a set of partial differential equations. In this case, the partial differential equations governing fluid flow, heat transfer and radiation exchange (surface-to-surface, surface-to-fluid and fluid-to-fluid) are the continuity equation, the Navier-Stokes equations and the energy balance. An approximate method (continuum fluid dynamics, CFID) has to be used in practical cases to determine the solution for these equations. The general solution method CFD is described briefly. First, the physical principles and equations are presented for a better understanding. Then, boundary conditions and model assumptions as well as used material parameters are shown. Finally, the discretization method and numerical algorithm for the finite element method (FEM) is described shortly.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Temperature loads in headlamps


    Weitere Titelangaben:

    Temperaturbelastung in Scheinwerfern


    Beteiligte:
    Wulf, J. (Autor:in) / Reich, A. (Autor:in)


    Erscheinungsdatum :

    2002


    Format / Umfang :

    10 Seiten, 12 Bilder, 3 Tabellen, 11 Quellen




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Deutsch




    Temperature loads in headlamps

    Wulf,J. / Reich,A. / Audi,Ingolstadt,DE | Kraftfahrwesen | 2002


    Temperature Loads in Headlamps

    Reich, Andreas / Wulf, Juergen | SAE Technical Papers | 2002


    Calculation of Temperature Loads in Headlamps

    Wulf, J. / Society of Automotive Engineers | British Library Conference Proceedings | 1998


    Calculation of Temperature Loads in Headlamps

    Wulf, Juergen | SAE Technical Papers | 1998


    Calculation of temperature loads in headlamps

    Wulf,J. / Bosch,Stuttgart,DE | Kraftfahrwesen | 1998