Arrays of sensors and actuators designed to provide robust broadband feedback control with high performance and limited modeling are the subject of this paper. The reconfigurable array technique proposed enables the design of reduced-order controllers for complex structures and offers the potential to improve closed-loop robustness and to broaden the region of good performance even as the plant changes. The weighted summation of sensor signals senses the modes that are relevant to performance while rejecting the remaining modes; therefore reducing the required complexity of the controller. These weights are obtained from the minimization of a cost function and, under certain assumptions, it can be shown that a single optimum solution exists. The use of reconfigurable arrays is motivated by the need to control the vibration of complex structures. A thirty element collocated actuator and sensor array was bonded to a cylinder section. Array weights were computed and successfully applied to isolate target modes. Different methods of computing the weights are implemented and compared. The deleterious effects of spatial aliasing and the performance as a function of the array size are experimentally explored.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Reconfigurable arrays of collocated sensors and actuators for modal isolation


    Beteiligte:
    Fripp, M.L. (Autor:in) / Atalla, M.J. (Autor:in) / Hagood, N.W. (Autor:in)


    Erscheinungsdatum :

    2000


    Format / Umfang :

    13 Seiten, 15 Quellen




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch