Leading European automotive manufacturers, steel manufacturers and researchers have joined in a research programme to investigate the three-dimensional (3D) measurement of steel sheet panels used in automotive manufacture. This paper describes the results of a large variability round-robin investigation shared between all the partners. The investigation has two parts. Firstly a general variability round-robin study has been performed where each partner measured a standard set of samples using their own equipment and calculated the parameters using their own software. Secondly a software variability round-robin study has been performed using the same raw data which was analysed using propriety software employed by each partner. The results and variability ranges will be presented. The conclusions will provide a set of guidelines to be used by manufacturers when using 3D surface measurements to assess manufactured surfaces.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Software variability in three-dimensional measurement of autobody steel panel surfaces


    Weitere Titelangaben:

    Einflüsse von Softwareunterschieden bei der 3D-Oberflächenmessung von Stahl-Karosserieteilen von Fahrzeugen


    Beteiligte:
    Sacerdotti, F. (Autor:in) / Griffiths, B.J. (Autor:in) / Butler, C. (Autor:in) / DeLaRue, T. (Autor:in) / Jonasson, M. (Autor:in) / Liraut, G. (Autor:in) / Rosen, B.G. (Autor:in) / Scheers, J. (Autor:in) / Scott, P. (Autor:in) / Segala, A. (Autor:in)


    Erscheinungsdatum :

    2000


    Format / Umfang :

    13 Seiten, 10 Bilder, 4 Tabellen, 12 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Hardware variability in the three-dimensional measurement of autobody steel panel surfaces

    Sacerdotti, F. / Griffiths, B.J. / Benati, F. et al. | Tema Archiv | 2001


    Laboratory Perforation Corrosion Tests of Autobody Steel Sheet

    Townsend, H. E. / SAE | British Library Conference Proceedings | 1997


    Laboratory perforation corrosion tests of autobody steel sheet

    Townsend,H.E. / Bethlehem Steel,US | Kraftfahrwesen | 1997


    Laboratory Perforation Corrosion Tests of Autobody Steel Sheet

    Townsend, Herbert E. | SAE Technical Papers | 1997


    Dynamic denting of autobody panels

    Burley,C.E. / Niemeier,B.A. / Koch,G.P. et al. | Kraftfahrwesen | 1976