Modelling and measurement of the fibre orientation distribution within a reinforced thermoplastic automotive clutch pedal are presented. Products have been manufactured on an injection moulding machine equipped with accurate process monitoring. The fibre orientation distributions at selected points within the pedal were measured using a fully automated, polished section/reflection microscopy image analysis system. Simulation was undertaken using commercial software with a fibre orientation prediction algorithm. The predicted fibre orientation distributions are compared with experimental results in order to assess the accuracy of the software in both thin and thick (nearly equal to 5 mm) sections of the pedal.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Glass fibre orientation within injection moulded automotive pedal. Simulation and experimental studies


    Weitere Titelangaben:

    Glasfaserorientierung in einem spritzgegossenen Kupplungspedal - Simulierung und experimentelle Untersuchung


    Beteiligte:
    Whiteside, B.R. (Autor:in) / Coates, P.D. (Autor:in) / Hine, P.J. (Autor:in) / Duckett, R.A. (Autor:in)


    Erscheinungsdatum :

    2000


    Format / Umfang :

    8 Seiten, 13 Bilder, 2 Tabellen, 17 Quellen



    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    INJECTION MOULDED PANEL

    LUSTED IAN MARK WYNDHAM / COX ROY | Europäisches Patentamt | 2015

    Freier Zugriff

    Automotive door pedal

    CHEN WEIZHEN | Europäisches Patentamt | 2023

    Freier Zugriff

    Automotive Door Pedal

    CHEN WEIZHEN | Europäisches Patentamt | 2023

    Freier Zugriff

    INJECTION-MOULDED PART AND METHOD FOR PRODUCING INJECTION-MOULDED PART

    GUDLIN ZSOFIA | Europäisches Patentamt | 2021

    Freier Zugriff

    Automotive, moulded visco-elastic foams

    Farkas, P. / Stanciu, R. / Mendoza, L. | Tema Archiv | 2002