Full-scale roller rigs for tests on a single axle enable the investigation of several dynamics and durability problems related with the design and operation of the railway rolling stock. In order to exploit the best potential of this test equipment, appropriate test procedures need to be defined, particularly in terms of actuators’ references, to make sure that meaningful wheel –rail contact conditions can be reproduced. The aim of this paper is to propose a new methodology to define the forces to be generated by the actuators in the rig in order to best reproduce the behaviour of a wheel set and especially the wheel –rail contact forces in a running condition of interest as obtained either from multi-body system (MBS) simulation or from on-track measurements. The method is supported by the use of a mathematical model of the roller rig and uses an iterative correction scheme, comparing the time histories of the contact force components from the roller rig test as predicted by the mathematical model to a set of target contact force time histories. Two methods are introduced, the first one considering a standard arrangement of the roller rig, the second one assuming that a differential gear is introduced in the rig, allowing different rolling speeds of the two rollers. Results are presented showing that the deviation of the roller rig test results from the considered targets can be kept within low tolerances (1% approximately) as far as the vertical and lateral contact forces on both wheels are concerned. For the longitudinal forces, larger deviations are obtained except in the case where a differential gear is introduced.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A method for testing railway wheel sets on a full-scale roller rig


    Beteiligte:
    Liu, Binbin (Autor:in) / Bruni, Stefano (Autor:in)

    Erschienen in:

    Vehicle System Dynamics ; 53 , 9 ; 1331-1348


    Erscheinungsdatum :

    2015-09-02


    Format / Umfang :

    18 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    A method for testing railway wheel sets on a full-scale roller rig

    Liu,B. / Bruni,S. / Politecnico di Milano,IT | Kraftfahrwesen | 2015



    Full-scale railway wheel flat experiments

    Jergéus, J / Odenmarck, C / Lundén, R et al. | SAGE Publications | 1999


    Full-scale railway wheel flat experiments

    Jergeus, J. / Odenmarck, C. / Lunden, R. et al. | British Library Online Contents | 1999


    Full-scale railway wheel flat experiments

    Jergeus, J. / Odenmarck, C. / Lunden, R. et al. | Tema Archiv | 1999