The protrusion between inlet valve seat machining surface and combustion chamber casting surface effects tumble ratio of high BTE (>40%) GTDI engine flow box. Tumble ratio could increase by appropriate step, and decrease by higher or lower step. CFD results show that protrusion machined by one-process can get better tumble ratio than two-processes. Using FEV evaluation methodology, some variants were taken into this research, upper tolerance (+0.36 mm) step shows nearly same charge motion level like nominal flow box (+0.1 mm) and reaches only slightly lower first tumble peak, bottom tolerance (−0.16 mm) step shows lower first tumble peak but at second tumble peak difference are small. All designs in the tolerance reach the same TKE around spark plug at igniting time. It’s a very low and similar wall film level for all steps in the range of tolerance. At last, two prototype cylinder head samples with +0.1 mm and +0.25 mm step were tested on AVL flow test bench. The result shown that the tumble ratio of +0.1 mm step increase 4.3%, but coefficient flow decreases 3.3%, following with CFD result trend.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Study of Inlet Valve Seat Protrusion Effect on GTDI Engine Flow Box


    Weitere Titelangaben:

    Lect. Notes Electrical Eng.


    Beteiligte:
    Wang, Ming-ming (Autor:in) / Zhang, Yong-gang (Autor:in) / Liu, Dong (Autor:in) / Zhang, Gui-qiang (Autor:in)


    Erscheinungsdatum :

    2022-01-13


    Format / Umfang :

    13 pages





    Medientyp :

    Aufsatz/Kapitel (Buch)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Study of Inlet Valve Seat Protrusion Effect on GTDI Engine Flow Box

    Wang, Ming-ming / Zhang, Yong-gang / Liu, Dong et al. | TIBKAT | 2022


    Study of Inlet Valve Seat Protrusion Effect on GTDI Engine A Flow Box

    Wang, Ming-ming / Zhang, Yong-gang / Liu, Dong et al. | TIBKAT | 2022


    Additive manufacturing enhances GTDI pistons

    Belmonte,M.A. / Akehurst,S. / Copeland,C.D. et al. | Kraftfahrwesen | 2016


    A Study on Charge Motion Requirements for a Class-Leading GTDI Engine

    Breuer, Albert / Ruhland, Helmut / Dunstheimer, Jens et al. | SAE Technical Papers | 2017


    Launch Performance Optimization of GTDI-DCT Powertrain

    Cho, David / Dai, Edward / Pietron, Gregory et al. | SAE Technical Papers | 2015