The minimum thickness of the oil film lubricating piston rings was measured successfully under motoring conditions by means of Eddy Current Sensors which were mounted on the liner. The measurements show the influences of engine speed, the viscosity of the oils and the profile of rings on their lubrication. The results also show the effects of hydrodynamic lubrication and oil starvation at the inlet of the rings. Under motoring condition, the minimum oil film thickness has no significant difference for the four strokes and it reaches a minimum value even though the rings are fully lubricated(without oil ring).


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    An Experimental Investigation of the Oil Film Lubricating Piston Rings


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Jijun, Li (Autor:in) / Shenghua, Liu (Autor:in) / Rong, Wei (Autor:in) / Longbao, Zhou (Autor:in)

    Kongress:

    1996 SAE International Fall Fuels and Lubricants Meeting and Exhibition ; 1996



    Erscheinungsdatum :

    1996-10-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    An experimental investigation of the oil film lubricating piston rings

    Shjenghua,L. / Jijun,L. / Longbao,Z. et al. | Kraftfahrwesen | 1996


    An experimental investigation of the oil film lubricating piston rings

    Shenghua,. / Jijun,L. / Lonbao,Z. et al. | Kraftfahrwesen | 1996


    An Experimental Study on Effect of Piston Friction and Lubricating Oil Consumption on Lower Tension Piston Rings

    Iijima, N. / Aoki, A. / Imamura, J. et al. | British Library Conference Proceedings | 2009


    The Effects of Piston Rings and Liner Break-in on Lubricating Condition

    Wakabayashi, R. / Kawanishi, M. / Yoshida, H. et al. | British Library Conference Proceedings | 2007


    The effects of piston rings and liner break-in on lubricating condition

    Wakabayashi,R. / Kawanishi,M. / Yoshida,H. et al. | Kraftfahrwesen | 2007