This specification covers established manufacturing tolerances applicable to bars, rods, and wire of nickel, nickel alloy, and cobalt alloys ordered to inch-pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term "excl" is used to apply only to the higher figure of a specified range. AMS2261K results from a Limited Scope Ballot to correct errors in paragraph references for Out of Roundness (7.1).
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
2012-10-08
Aufsatz (Konferenz)
Englisch
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2007
TOLERANCES Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 1994
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2019
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2009
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2006