Vehicle pitch and drop has become an important subject to crash analysis due to the recent FMVSS208 requirements for unbelted occupant. During frontal impact, the excessive header drop due to significant vehicle pitch and drop can induce the contact between occupant's head and sun visor. To avoid this issue, structure design for reducing vehicle pitch and drop is essential to crash safety. Historically, CAE simulation has been used in structure design during vehicle development process. Therefore, the quality of CAE modeling for replicating vehicle pitch and drop at physical test is crucial for assisting the structure design. In this paper, the most effective components in CAE model to vehicle pitch and drop have been identified and ranked by using the results of the sensitivity study. Hence the model quality can be emphasized on those major components including front horn, kick-down of front frame, body structure at upper load path, and body mounts. In addition to the sensitivity study, other important factors affecting the accuracy of CAE simulation for pitch and drop are also discussed. These factors are the mass distribution, gravity, tire, and suspension modeling. Due to the gravity effect, the suspension and structure components in test vehicle are compressed and initially remain at equilibrium state. This is different than the CAE simulation where it usually starts without pre-loaded structure. To compensate the discrepancy of initial conditions between CAE and actual test, a simplified subtraction method is suggested. The CAE results with suggested modeling practices demonstrate reasonable correlations to the test data.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Important Modeling Practices in CAE Simulation for Vehicle Pitch and Drop


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Chang, J. Michael (Autor:in) / Cheng, James (Autor:in) / El-bkaily, Marwan (Autor:in) / Ali, Mohammad (Autor:in) / Craig, Ryan (Autor:in) / Tyan, Tau (Autor:in)

    Kongress:

    SAE 2006 World Congress & Exhibition ; 2006



    Erscheinungsdatum :

    2006-04-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Important modeling practices in CAE simulation for vehicle pitch and drop

    Chang,J.M. / Ali,M. / Craig,R. et al. | Kraftfahrwesen | 2006


    Structural optimization for vehicle pitch and drop

    Chang,J.M. / Huang,M. / Tyan,T. et al. | Kraftfahrwesen | 2006


    Structural Optimization for Vehicle Pitch and Drop

    Li, G. / Chang, J. Michael / Gu, L. et al. | SAE Technical Papers | 2006


    Modeling and Design for Vehicle Pitch and Drop of Body-on-Frame Vehicles

    Chang, J. M. / Rahman, M. / Ali, M. et al. | British Library Conference Proceedings | 2005


    Modeling and Design for Vehicle Pitch and Drop of Body-on-Frame Vehicles

    Chang, J. Michael / Cheng, James / El-Bkaily, Marwan et al. | SAE Technical Papers | 2005