The desired milling process with high material removal rate (MRR) and low surface roughness of the product can be achieved only if machining chatter is absent. Incorporating chatter into the optimal selection of the machining parameters leads to a complex problem. Therefore, the approach of selecting conservative intervals for the machining parameters is usually employed instead. In this paper, a practical approach is proposed to specify the optimal machining parameters (depth of cut and spindle speed) in order to maximize MRR and minimize forced vibrations by considering machining chatter. Firstly, the worst-case scenario-based optimization problem in terms of the surface quality is solved to find the critical time at which maximal amplitude vibrations occur. Then, the time dependency of the problem is eliminated. Secondly, the multi-objective optimization is conducted to achieve the Pareto Optimal Front (POF). The Stability Lobe Diagram (SLD) is obtained independently through well-established analytical methods. Optimal machining parameters on the obtained POF are mapped into the SLD to represent optimal results for the cases at which machining chatter is absent. Finally, these optimal results are sorted by the Technique for Order of Preference by Similarity to Ideal Solution (TOPSIS) decision-making method and displayed on the combined POF-SLD diagram which can be used by the machining operator for determination of the process parameters. A case study is considered, illustrating the efficiency of the proposed method.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A New Method for Multi-objective Optimal Design of Milling Parameters by Considering Chatter Vibrations


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Sohani, A. (Autor:in) / Jafarzadeh, E. (Autor:in) / Khodaygan, S. (Autor:in)

    Kongress:

    Automotive Technical Papers ; 2019



    Erscheinungsdatum :

    2019-05-13




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch


    Schlagwörter :


    Chatter stability in robotic milling

    Cordes, Marcel / Hintze, Wolfgang / Altintas, Yusuf | BASE | 2019

    Freier Zugriff

    Chatter vibrations of high-performance motorcycles

    Sharp, R. S. / Watanabe, Y. | Taylor & Francis Verlag | 2013


    Multiple chatter frequencies in milling processes

    Insperger, T. | Online Contents | 2003


    Simulation of Chatter Vibrations for Wiper Systems

    Grenouillat, R. / Leblanc, C. / Society of Automotive Engineers | British Library Conference Proceedings | 2002


    Simulation of Chatter Vibrations for Wiper Systems

    Leblanc, Christian / Grenouillat, Régis | SAE Technical Papers | 2002