Torsion beam suspensions are lightweight and low in cost, and they are therefore frequently used as the rear suspensions of small front-wheel drive vehicles. However, it is difficult to predict their characteristics and to satisfy performance targets in the early stages of development in particular, because the various aspects of performance required of a suspension must be achieved by a single structure. A great deal of research has been conducted into the cross-sectional shape of the beam section; however, this paper focuses on the effect of the properties of the trailing arms on suspension characteristics.Two similar test torsion beam suspensions differing only in the rigidity of the trailing arms were fabricated, and kinematics and compliance (K&C) tests were conducted using a 3D measurement system.The lateral compliance test showed the anticipated result that change in toe and camber is greater in the suspension with lower rigidity trailing arms. On the other hand, the roll motion test indicated that the lower rigidity arms had substantially greater toe change as well. Analysis of displacement at each measurement point showed that lateral movement becomes larger toward the ends of the trailing arms in a linear manner. This result indicates that the difference in toe change originates from the restraint of the trailing arms by the torsion beam, and not from the deflection of the trailing arms themselves. This mechanism was verified via FEM simulations.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Elastokinematic Characteristics of Torsion Beam Suspensions


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    SAE 2015 World Congress & Exhibition ; 2015



    Erscheinungsdatum :

    2015-04-14




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch


    Schlagwörter :


    Elastokinematic characteristics of torsion beam suspensions

    Shibue,H. / Srivastava,D. / Honda Research and Development,JP | Kraftfahrwesen | 2015


    Elastokinematic Analysis of Compound Crank Axle Suspensions

    Vitale, Emilio / Frendo, Francesco | SAE Technical Papers | 2009


    Design of a Torsion Beam Suspension with an Optimized Elastokinematic Behavior

    Koga, Adriano Akio / Carneiro, Guilherme Costa / da Costa, Gustavo Araújo et al. | SAE Technical Papers | 2013


    Elastokinematic Analysis and Optimization of Suspension Compliance Characteristics

    Ju Seok Kang / Jung Rak Yun / Jang Moo Lee et al. | British Library Conference Proceedings | 1997


    Elastokinematic Analysis and Optimization of Suspension Compliance Characteristics

    Lee, Jang Moo / Kang, Ju Seok / Yun, Jung Rak et al. | SAE Technical Papers | 1997