The transport sector is one of the major parties responsible for carbon dioxide (CO2) and pollutants emissions in Europe. For this reason, one of the main commitments of the European Commission is its decarbonization by 2035/2040. To achieve this target, during the last decades, different propulsion technologies were developed such as hybrid electric vehicles (HEVs), plug-in electric vehicles (PHEVs), and battery electric vehicles (BEV). The first two proposals can be considered as bridging technology between the internal combustion engine (ICE) and the BEV because they offer at the same time comparable performance as conventional powertrains and improved efficiency. However, both technologies are struggling with the tightening of pollutants and CO2 limits. On the other hand, the BEV can offer zero emissions at the tailpipe, but it suffers from limited range capabilities and the lack of fast-charging infrastructures. Within this context, the fuel cell vehicle (FCV) appears as an interesting opportunity because it offers zero tailpipe emissions and equivalent refuelling time of the ICE. This article evaluates through mathematical simulations the performance of two fuel cell electric buses (FCEBs), which are supposed to work respectively in urban and highway driving conditions. The urban bus is equipped with a single fuel cell (FC) module of 85 kW-Net and an electric motor (EM) of 225 kW. The intercity bus is equipped with two FC modules with a total power of 170 kW-Net and two EMs of 225 kW each. A sensitivity to the battery capacity from 20 kWh to 40 kWh was performed for both FECBs. The power split between the FC module and the high-voltage battery was optimized with the Equivalent Consumption Minimization Strategy (ECMS). The two FCEBs were tested considering different portfolios of cycles: in the case of the urban bus in Braunschweig and the Standardized On-Road Test Cycles SORT1 and SORT2 were assumed as a reference, while cycles like the Highway Fuel Economy Test (HWFET), European Transient Cycle (ETC), and cruising at 100 km/h were assumed as reference for the intercity. Simulation results highlighted that the increase of battery capacity in the case of the urban bus from 20 kWh to 30 kWh reduces hydrogen (H2) consumption by 11% along the Braunschweig cycle. On the other hand, in the case of the intercity bus, the fuel consumption is less affected by the increase of capacity in the same range. In this case a reduction of 4.7% is estimated for the HWFET cycle, and it is less than 1% in the case of cruising conditions.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Design of Two Fuel Cell Buses for Public Transport According to Two Different Operating Scenarios: Urban and Motorway


    Weitere Titelangaben:

    Sae Int. J. Elec. Veh


    Beteiligte:


    Erscheinungsdatum :

    2023-06-22




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Experiences from fuel cell buses and ethanol buses in public transport in Stockholm

    Stromberg, J. / Association for European Transport | British Library Conference Proceedings | 2005


    Aspects of urban motorway design

    Cullen, J.M. | Engineering Index Backfile | 1966


    Fuel Consumption on Urban Buses

    Alleo, Paulo / Mastrobuono, Renato C. / Chaves, Rodrigo et al. | SAE Technical Papers | 2005


    All change? Motorway interchanges for public transport

    Bowers, Simon P. | Online Contents | 2011


    FACTORS INFLUENCING THE HYBRID DRIVE OF URBAN PUBLIC TRANSPORT BUSES

    Dalibor BARTA / Martin MRUZEK | DOAJ | 2015

    Freier Zugriff