Due to its high benefit-cost ratio, decreasing mechanical friction losses in internal combustion engines represents one of the most effective and widely applicable solutions for improved engine efficiency. Especially the piston group - consisting of piston, rings and pin - shows significant potential for friction reduction, which can be evaluated through extensive experimental parameter studies. For each investigated variant, the steady-state friction measurements are fitted to an empirical polynomial model. In order to calculate the associated fuel consumption and CO2 emissions in transient driving cycles, the steady-state friction model is used in a map-based vehicle simulation. If transient engine operation entails friction phenomena that are not included in the steady-state model, the simulation could yield erroneous fuel consumption and CO2 predictions. This issue is gaining in importance with the current regulatory driving cycles, which aim to better reflect real-world driving conditions and thus contain more frequent and steep transient events. Therefore, the purpose of this study is to assess the extent to which it is valid to use a steady-state friction model for the determination of CO2 emissions in transient driving cycles. To do so, fired friction measurements are taken using the indication method both (i) with artificial speed and load ramps at constant oil and coolant temperatures, and (ii) at a constant operating point with increasing oil and coolant temperatures. For an overall model validation, a detailed comparison between steady-state friction model and transient friction measurements is made in two regulatory driving cycles and a real-world driving profile. The results demonstrate that under specific operating conditions, a dynamic friction behavior due to a temperature lag of the engine components can lead to momentary friction differences compared to the steady-state values. The validation, however, indicates that these differences appear to be small in driving cycles. Additionally, it could be shown that dynamic friction phenomena only have a minor effect on cumulative fuel consumption in comparison to the influence of the inherent uncertainty of the steady-state friction model.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Validity of a Steady-State Friction Model for Determining CO2 Emissions in Transient Driving Cycles


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Ehnis, Holger (Autor:in) / Bargende, Michael (Autor:in) / Kuenzel, Reiner (Autor:in) / Funk, Tobias (Autor:in)

    Kongress:

    14th International Conference on Engines & Vehicles ; 2019



    Erscheinungsdatum :

    2019-09-09




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Measured emissions of small engines under steady state and transient operation

    Brereton,G.J. / Morrison,K. / Chishty,H.A. et al. | Kraftfahrwesen | 1994


    Measured Emissions of Small Engines under Steady State and Transient Operation

    Patterson, D. J. / Schwartz, G. / Brereton, G. J. et al. | SAE Technical Papers | 1994


    Driving cycles for emissions measurements under European conditions

    Andre,M. / Hickman.A.J. / Hassel,D. et al. | Kraftfahrwesen | 1995


    Particle Emissions from SI-Engines During Steady State and Transient Operating Conditions

    Kasper, A. / Kittelson, D. B. / Weingartner, E. et al. | SAE Technical Papers | 2005


    EGR Transient Operations in Highly Dynamic Driving Cycles

    Galindo, Jose / Climent, Hector / Pla, Benjamin et al. | Springer Verlag | 2020