Damping measurements on vehicle subsystems are rarely straightforward due to the complexity of the dynamic interaction of system joints, trim, and geometry. Various experimental techniques can be used for damping estimation, such as frequency domain modal analysis curve-fitting methods, time domain decay-rate methods, and other methods based on energy and wave propagation. Each method has its own set of advantages and drawbacks. This paper describes an analytical and an experimental comparison between two, widely used loss factor estimation techniques frequently used in Statistical Energy Analysis (SEA).The single subsystem Power Injection Method (PIM) and the Impulse Response Decay Method (IRDM) were compared using analytical models of a variety of simulated simple spring-mass-damper systems. Frequency averaged loss factor values were estimated from both methods for comparison. The parameters of the analytical models were varied to study the effects of the total number of modes, amount of damping, location of modes within frequency bands, and the width of the frequency bands on loss factor estimation.The analytical study showed that both methods give accurate loss factor values as long as one modal resonance is present in each frequency band and as long as the damping values remain realistic for linear systems. These analytical results were confirmed experimentally by measuring the loss factors of simple steel plates, with and without damping treatments applied.
A Comparison Between Power Injection and Impulse Response Decay Methods for Estimating Frequency Averaged Loss Factors for SEA
Sae Technical Papers
SAE 2003 Noise & Vibration Conference and Exhibition ; 2003
2003-05-05
Aufsatz (Konferenz)
Englisch
Predictability Estimating for Room Impulse Response
IEEE | 2008
|Impulse Response Dynamic Stiffness Decay in Aging General Aviation Airfield Pavements
Transportation Research Record | 2012
|The relevance of frequency averaged properties
NTRS | 1968
|Impulse Response Dynamic Stiffness Decay in Aging General Aviation Airfield Pavements
Online Contents | 2012
|