Mobility method is used to analyze the steady-state performance of crankshaft and connecting rod bearings which are subjected to loads whose magnitude and direction both vary in time. The steady-state characteristics include journal center orbit, minimum film thickness, maximum film pressure, effective temperature, flow through the bearing, etc. To extract the stiffness and damping coefficients over the load cycle, linear analysis method based on a short-bearing approximation is employed. In addition, the oil flow through the main and connecting rod bearings is investigated. Sufficient lubrication conditions for these bearings are discussed. This combined analysis is supported by numerical simulations.The case studies are based on AlliedSignal's two-cylinder truck air brake compressor, TU-FLO 550, which illustrate the entire approach.
Static and Dynamic Analysis of Bearings for Truck Brake Compressor
Sae Technical Papers
International Truck & Bus Meeting & Exposition ; 1998
1998-11-16
Aufsatz (Konferenz)
Englisch
Static and dynamic analysis of bearings for truck brake compressor
Kraftfahrwesen | 1998
|Analytical solution of piston pack lubrication for truck air brake compressor
Kraftfahrwesen | 1999
|Analytical Solution of Piston Ring Pack Lubrication for Truck Air Brake Compressor
SAE Technical Papers | 1999
|DYNAMIC BRAKE RESISTOR, DYNAMIC BRAKE RESISTOR UNIT, AND DUMP TRUCK OF ELECTRIC DRIVE SYSTEM
Europäisches Patentamt | 2021
|