Spray angle and penetration length data were taken under cold start conditions for a Direct Injection Spark Ignition engine to investigate the effect of transient conditions on spray development. The results show that during cold start, spray development depends primarily on fuel pressure, followed by Manifold Absolute Pressure (MAP). Injection frequency had little effect on spray development. The spray for this single hole, pressure-swirl fuel injector was characterized using high speed imaging. The fuel spray was characterized by three different regimes. Regime 1 comprised fuel pressures from 6 - 13 bar, MAPs from 0.7 - 1 bar, and was characterized by a large pre-spray along with large drop sizes. The spray angle and penetration lengths were comparatively small. Regime 2 comprised fuel pressures from 30 - 39 bar and MAPs from 0.51 - 0.54 bar. A large pre-spray and large drop sizes were still present but reduced compared to Regime 1. The spray angle and penetration lengths were typically larger then in Regime 1. Regime 3 comprised fuel pressures from 65 - 102 bar and MAPs from 0.36 - 0.46 bar. The fuel spray had a fully developed hollow cone structure with recirculation vortices at the edges of the spray, which constricted the spray angle. The spray angle was similar to Regime 2, while the penetration length increased. The pre-spray and drop size were reduced compared to Regime 2. In all regimes, decreasing MAP enlarged the spray angle, while injection frequency was not a significant factor.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Spray Characterization in a DISI Engine During Cold Start: (1) Imaging Investigation


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    SAE 2006 World Congress & Exhibition ; 2006



    Erscheinungsdatum :

    2006-04-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Spray characterization in a DISI engine during cold start: (1) imaging investigation

    Gandhi,A.H. / Weaver,C.E. / Curtis,E.W. et al. | Kraftfahrwesen | 2006


    Spray characterization in a DISI engine during cold start: (2) PDPA investigation

    Gandhi,A.H. / Weaver,C.E. / Curtis,E.W. et al. | Kraftfahrwesen | 2006


    Spray Characterization in a DISI Engine During Cold Start: (2) PDPA Investigation

    Gandhi, Anand H. / Anderson, Carl L. / Weaver, Corey E. et al. | SAE Technical Papers | 2006


    An Optical Analysis of a DISI Engine Cold Start-Up Strategy

    Garner, Colin P. / Richardson, David / Hargrave, Graham K. et al. | SAE Technical Papers | 2015


    Model Based E85 Cold Start Optimization for DISI Engines

    Maass, J. / Günther, M. / Kratzsch, M. et al. | SAE Technical Papers | 2009