Hardware-in-the-Loop Simulation is a technology where the actual vehicles, engines or other components are replaced by a real-time simulation in a simulation computer, based on a mathematical model. That simulation reads ECU (Electronic Control Unit) output signals which would normally go to actuators. On the other hand the simulation must output the sensor signals which make the ECU ‘think’ it controls a real system. Generating these signals can be very difficult. Signals may be complex, depend on on-line computed variables, and be required to be output at high timing resolution. This paper describes the problems and presents a solution which employs high-performance Digital Signal Processors (DSP) to generate such signals on-line by Direct-Digital-Synthesis (DDS).


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    DSP-Based Automotive Sensor Signal Generation for Hardware-in-the-Loop Simulation


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    International Congress & Exposition ; 1994



    Erscheinungsdatum :

    1994-03-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch







    Hardware in the Loop Simulation of Embedded Automotive Control Systems

    Short, M. / Pont, M. J. / IEEE | British Library Conference Proceedings | 2005


    Applications of Hardware-in-the-Loop Simulation in Automotive Embedded Systems

    Meng, Aidong / Sultan, Myrna / Ahmad, Nadeem | SAE Technical Papers | 2020