This part of SAE J968 specifies two types of calibrating nozzle and holder assemblies intended for the testing and setting of diesel injection pumps on test benches. It applies to: a A calibrating nozzle and holder assembly with a single hole orifice plate; b A calibrating nozzle and holder assembly with a delay pintle type nozzle. The approximate range of the calibrating nozzle and holder assembly is up to: a 300 mm3/stroke with the single hole orifice plate; b 150 mm3/stroke with the delay pintle type nozzle. Setting and maintenance requirements are specified in ISO 4008/3. SAE J968/1 has been reaffirmed to comply with the SAE Five-Year Review policy.
Diesel Injection Pump Testing - Part 1: Calibrating Nozzle and Holder Assemblies
2021-03-17
Aufsatz (Konferenz)
Englisch
Fuel pumps , Fuel injection , Nozzles , Pumps
Diesel Injection Pump Testing—Part 1: Calibrating Nozzle and Holder Assemblies
SAE Technical Papers | 2002
Diesel Injection Pump Testing - Part 1: Calibrating Nozzle and Holder Assemblies
SAE Technical Papers | 2015
DIESEL INJECTION PUMP TESTING—PART 1: CALIBRATING NOZZLE AND HOLDER ASSEMBLIES
SAE Technical Papers | 1995
DIESEL INJECTION PUMP TESTING—PART 1: CALIBRATING NOZZLE AND HOLDER ASSEMBLIES
SAE Technical Papers | 1991
Diesel Fuel Injection Pump - Validation of Calibrating Nozzle Holder Assemblies
SAE Technical Papers | 2015