Increasing the strength of materials is effective in reducing weight and boosting structural part performance, but there are cases in where the residual strain generated during the process of manufacturing of high-strength materials results in a decline of durability. It is therefore important to understand how the residual strain in a manufactured component changes due to processing conditions. In the case of a connecting rod, because the strain load on the connecting rod rib sections is high, it is necessary to clearly understand the distribution of strain in the ribs. However, because residual strain is generally measured by using X-ray diffractometers or strain gauges, measurements are limited to the surface layer of the parts. Neutron beams, however, have a higher penetration depth than X-rays, allowing for strain measurement in the bulk material. The research discussed within this paper consists of non-destructive residual strain measurements in the interior of connecting rods using the 2nd Generation Neutron Residual Stress Mapping Facility (NRSF2) at Oak Ridge National Laboratory, measuring the Fe (211) diffraction peak position of the ferrite phase. The interior strain distribution of connecting rod, which prepared under different manufacturing processes, was revealed. By the visualization of interior strains, clear understandings of differences in various processing conditions were obtained. In addition, it is known that the peak width, which is also obtained during measurement, is suggestive of the size of crystallites in the structure; however the peak width can additionally be caused by microstresses and material dislocations.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Non-Destructive Measurement of Residual Strain in Connecting Rods Using Neutrons


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Seid, Alan (Autor:in) / Fancher, Chris (Autor:in) / Matsuda, Hideki (Autor:in) / Bunn, Jeffrey (Autor:in) / Motani, Ryuta (Autor:in) / Okayama, Tatsuya (Autor:in) / Ikeda, Tomohiro (Autor:in)

    Kongress:

    WCX World Congress Experience ; 2018



    Erscheinungsdatum :

    2018-04-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Nondestructive Measurement of Residual Strain in Connecting Rods Using Neutrons

    Jeffery, Bunn R. / Fancher, Christopher M. / Matsuda, Hideki et al. | SAE Technical Papers | 2019


    Proving Connecting Rods

    Emerald Group Publishing | 1936


    Auxiliary connecting rods

    Wiegand, H. | Engineering Index Backfile | 1939


    Master connecting rods

    Taylor, C.F. | Engineering Index Backfile | 1933


    Honing connecting rods

    Engineering Index Backfile | 1933