This Standard defines uniform Quality and Technical requirements relative to metallic parts marking performed in using "Data Matrix symbology" (2D) coding used within the aerospace industry. The ISO 16022 specifies general requirements (data characters encodation, error correction rules, decoding algorithm, etc.). In addition to this specification, part Identification with such coding is subject to the following requirements to ensure electronic reading (scanning) ability of the symbol. The marking processes covered by this standard are as follows: Dot Peening Laser Marking Electro-Chem Etching Further marking processes will be included if required. Unless specified otherwise in the contractual business relationship, the company responsible for the design of the part shall determine the location of the Data Matrix Marking. Symbol position should allow illumination from all sides for readability. This standard does not specify information to be encoded, which are requested by customers, in conjunction with the ATA Spec 2000, chapter 9.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Data Matrix (2D) Coding Quality Requirements for Parts Marking


    Erscheinungsdatum :

    2002-02-26



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch






    Parts quality management: Direct part marking of data matrix symbol for mission assurance

    Moss, Chantrice / Chakrabarti, Suman / Scott, David W. | IEEE | 2013


    Marking of Plastic Parts

    SAE Technical Papers | 2017


    Marking of Rubber Parts

    SAE Technical Papers | 2013