Two methods are allowed in ISO 26262-5 for hardware analysis of random hardware failures. The 1st method is called “Evaluation of Probabilistic Metric for random Hardware Failures”. The 2nd method is called “Evaluation of each cause of safety goal violation”. Advantages of the 2nd method during development of ASIL D Generation 3 Electric Power Steering are presented in this paper. A reliability analysis is one of the important prerequisite for the hardware analysis and this paper shows the best practice for hardware part failure rate estimation using industry standards such as IEC TR 62380. The equally important focus is on a diagnostic coverage of each safety mechanism with respect to residual faults and with respect to relevant dual/latent point faults because any safety design can either benefit from low failure rates or from high diagnostic coverage of safety mechanism to mitigate faults. FMEA is highly recommended by ISO 26262-5 as a part of hardware analysis. There is an analogy between the 2nd method for hardware analysis and FMEA. The 2nd method may be considered an extension of standard FMEA techniques that also analyze the system effect of faults including SW interactions.
Advantages of the Alternative Method for Random Hardware Failures Quantitative Evaluation - a Practical Survey for EPS
Sae International Journal of Passenger Cars- Electronic and Electrical Systems
Sae Int. J. Passeng. Cars – Electron. Electr. Syst
SAE 2013 World Congress & Exhibition ; 2013
2013-04-08
12 pages
Aufsatz (Konferenz)
Englisch
Practical advantages of locomotive feed water heating
Engineering Index Backfile | 1922
Piloted Aircraft Simulation - Advantages, Disadvantages, and Practical Problems
SAE Technical Papers | 1978
|The Advantages of a Hardware Based Design Methodology
AIAA | 2013
|Survey of slope failures in reservoirs
TIBKAT | 1968
|