SAE J485 specifies the recommended nominal diameters and locations of holes in bolt or screw shanks, and nominal widths and depths of slots in nuts, for use with the recommended sizes of inch-series cotter pins, as shown in Table 1. J485 has been reaffirmed to comply with the SAE five-year review policy.
Holes in Bolt and Screw Shanks and Slots in Nuts for Cotter Pins
2013-04-16
Aufsatz (Konferenz)
Englisch
Holes in Bolt and Screw Shanks and Slots in Nuts for Cotter Pins
SAE Technical Papers | 2016
HOLES IN BOLT AND SCREW SHANKS AND SLOTS IN NUTS FOR COTTER PINS
SAE Technical Papers | 1998
COTTER PINS Corrosion Resistant Steel
SAE Technical Papers | 1945
COTTER PINS Corrosion Resistant Steel
SAE Technical Papers | 1950
COTTER PINS Corrosion Resistant Steel
SAE Technical Papers | 1940