This interface standard applies to fuzes/fuzing systems (referred to as fuzing system hereafter) in airborne weapons that use a MIL-STD-1760 type interface. It defines the powers, the discrete signals and the serial data interface for the communications at the interface between the fuzing system and the remainder of the weapon, including the weapon control unit. The Class 1 interface is an electrical only interface that facilitates use of MIL-STD-1760 type platform store interfaces for the fuze to monitor intentional release and defines the fuze interface bus communications protocol to allow sending and receiving data from fuzing systems. Class 2 interfaces add a defined connector and additional interfaces to facilitate the exchange of compatible fuzing systems. Class 3 interfaces add further interface definitions to facilitate the exchange of AS5680A compatible fuzing systems components. The bus communications protocol provides a means by which the weapon may set mission parameters within the fuzing system main housing and in other devices external to the fuzing system main housing. The standard also defines the target detection signal to be provided by a target detection device external to the fuzing system. This standard does not address the mechanical interfaces to target detection devices or to other sensors that are external to the fuzing system main housing. Document has been revised to include definitions for the following interfaces: 3 power supply; Initiation inhibit discrete interface; Target detection sensor interface; Post release environment sensor interface. These elements complete the definitions in the Standard of all elements necessary for the Class 2 and Class 3 interfaces for interchangeable fuzes. Also included are a small number of revisions to clarify elements of the previous standard that were unclear (definitions of bit mapping) and corrections to inconsistent tolerance margins.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Standard Electrical and Logical Interface for Airborne Fuzing Systems


    Erscheinungsdatum :

    2012-12-03



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch