This SAE Standard specifies the dimensional requirements necessary for the interchangeability of tapered shaft ends and hubs for fuel injection pumps of diesel engines.SAE J1419 has been cancelled because the content of this standard is fully covered by ISO 6519. Therefore, to eliminate such redundancy and confusion in coordinating the standards between ISO and SAE, this document is declared cancelled and superseded by ISO 6519.
Tapers for Shaft Ends and Hubs for Fuel Injection Pumps
2015-11-24
Aufsatz (Konferenz)
Englisch
Tapers for Shaft Ends and Hubs for Fuel Injection Pumps
SAE Technical Papers | 1999
Engineering Index Backfile | 1929
Marine Propeller-Shaft Ends and Hubs
SAE Technical Papers | 2015
Marine Propeller-Shaft Ends and Hubs
SAE Technical Papers | 2009
MARINE PROPELLER-SHAFT ENDS AND HUBS
SAE Technical Papers | 1980