Engine-out CO emission and fuel conversion efficiency were measured in a highly-dilute, low-temperature diesel combustion regime over a swirl ratio range of 1.44-7.12 and a wide range of injection timing. At fixed injection timing, an optimal swirl ratio for minimum CO emission and fuel consumption was found. At fixed swirl ratio, CO emission and fuel consumption generally decreased as injection timing was advanced. Moreover, a sudden decrease in CO emission was observed at early injection timings. Multi-dimensional numerical simulations, pressure-based measurements of ignition delay and apparent heat release, estimates of peak flame temperature, imaging of natural combustion luminosity and spray/wall interactions, and Laser Doppler Velocimeter (LDV) measurements of in-cylinder turbulence levels are employed to clarify the sources of the observed behavior. Mixing processes occurring after the pre-mixed burn are found to be the likely source of the optimal swirl ratio, while enhanced pre-combustion mixing dominates the reduction in CO with earlier injection. Liquid fuel films formed on the bowl lip are not found to significantly impact CO emissions, and increased injection pressure typically reduces CO emissions at this high dilution rate. Fuel conversion efficiency is examined in terms of component efficiencies related to combustion phasing, heat loss, and combustion efficiency. The influence of swirl and injection timing on each of these efficiencies is discussed.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    The Effect of Swirl Ratio and Fuel Injection Parameters on CO Emission and Fuel Conversion Efficiency for High-Dilution, Low-Temperature Combustion in an Automotive Diesel Engine


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Bae, Choongsik (Autor:in) / Choi, Dae (Autor:in) / Bergin, Michael (Autor:in) / Miles, Paul C. (Autor:in) / Reitz, Rolf D. (Autor:in) / Kook, Sanghoon (Autor:in)

    Kongress:

    SAE 2006 World Congress & Exhibition ; 2006



    Erscheinungsdatum :

    2006-04-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    The Effect of Injection Parameters and Swirl on Diesel Combustion with High Pressure Fuel Injection

    Tsujimura, Kinji / Shundoh, Shigeru / Kobayashi, Shinji et al. | SAE Technical Papers | 1991


    The effect of injection parameters and swirl on diesel combustion with high pressure fuel injection

    Skundoh,S. / Kagegawa,T. / Tsujimura,K. et al. | Kraftfahrwesen | 1991


    Effect of Swirl and Fuel Injection Characteristics on Premixed Phase of Diesel Combustion

    Tamma, Bhaskar / Mehta, Pramod S. | SAE Technical Papers | 1998


    Effect of Swirl and Fuel Injection Characteristics on Premixed Phase of Diesel Combustion

    Mehta, P. S. / Tamma, B. / Society of Automotive Engineers | British Library Conference Proceedings | 1998