The prime function of crown wheel pinion is to receive the power from transmission & distribute to two-wheel ends. Doing so these members will experience the tremendous bending fatigue. Shot peen is the one of the latest technology used to improve the bending fatigue of the CWP [1]. In this particular case- six CWP are taken for the study to understand the effect of the operations after shot peen process. Three Samples are named as batch A, another 3 samples are named as batch B. Both the batch CWP are shot peened. Then as a regular production practice the batch A CWP are process through hard turning ➔ Abrasive lapping ➔ Hot lubriting (manganese phosphate) ➔ Fully finish ready for assembly. Then both the batch A & batch B samples are taken for residual stress analysis using X-Ray diffraction technique. The measurement location is 50 microns below the surface. The results tabulated, found that batch A samples shows decrease in Residual stress relatively to batch B. This evident that post operations after shot peen process reduces the induced compressed residual stress. This phenomenon is due to material crystal lattice relaxed to original orientation or few of them change over to new orientation, particularly d spacing & angle [2]. The drop in residual stress was approx. 10 to 15% at depth of 50 Micron from the surface. Residual stress drop is not to zero because post operations are not strong enough to nullify the induced compressive residual stress. The study shows that abrasive lapping & hot lubrite operation reduces the induced shot peen compressive residual stress to some extent which could lower the root bending fatigue life of the CWP.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A Case Study on Effect of Subsequent Operations on Shot Peened Crown Wheel Pinion (Hypoid Gear Set) & Compressive Residual Stress Analysis


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Rao, Yathish (Autor:in)

    Kongress:

    Symposium on International Automotive Technology ; 2021



    Erscheinungsdatum :

    2021-09-22




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Orbitally formed hypoid pinion gear

    MAKKE ALAA / GIBSON CAMERON / TOJCIC STEFAN et al. | Europäisches Patentamt | 2021

    Freier Zugriff


    HYPOID GEAR LUBRICATION

    Willey, A. O. | SAE Technical Papers | 1939


    POWER TRANSFER ASSEMBLY WITH HYPOID GEARSET HAVING OPTIMIZED PINION UNIT

    KETCHEL BRADLEY / SMITH WADE / LARSON RALPH et al. | Europäisches Patentamt | 2019

    Freier Zugriff

    Power transfer assembly with hypoid gearset having optimized pinion unit

    KETCHEL BRADLEY / SMITH WADE / LARSON RALPH et al. | Europäisches Patentamt | 2021

    Freier Zugriff