A cycle-resolved test system was designed in a Two Stage Direct Injection (TSDI) Gasoline engine to simulate the engine quick start process in an Integrated Start and Generator (ISG) Hybrid Electric Vehicle (HEV) system.Based on the test system, measurement of the in cylinder HC concentrations near the spark plug under different engine coolant temperature and cranking speed conditions were conducted using a Fast Response Flame Ionization Detector (FFID) with Sampling Spark Plug (SSP) fits, then the in-cylinder equivalence ratio near the spark plug was estimated from the measured HC concentrations. In addition, the effects of the 1st injection timing, 2nd injection timing, and total equivalence ratio on the mixture formation near the spark plug were analyzed by means of experiments.Results showed that coolant temperature, cranking speed, fuel injection timing especially the 2nd injection timing and total equivalence ratio play a substantial part in the mixture formation of the TSDI engine. Compared with that under the condition of 10°C, peak HC concentrations increased by 30% at the coolant temperature of 85°C and equivalence ratio near the spark plug at TDC get s an increase. HC concentrations near the spark plug at TDC is decreased by 51.7% and equivalence ratio near the spark plug at TDC has got a reduction at the cranking speed of 1400r/min, compared with that at 400r/min. HC concentrations increased with the advance of the 1st and the 2nd injection timing BTDC. Peak HC concentrations increase obviously and equivalence ratio near the spark plug at TDC increases when the 1st injection timing advanced from 190°CA BTDC to 290°CA BTDC and the 2nd injection timing advanced from 20°CA BTDC to 80°CA BTDC. When the total equivalence ratio increases from 0.85 to 1.19, equivalence ratio near the spark plug at TDC gets an increase.Based on these measurements the optimal parameter setting for every subsequent ignition during the engine start-up can be derived.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Investigations on Mixture Formation during Start-UP Process of a Two-Stage Direct Injection Gasoline Engine for HEV Application


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Lu, Haifeng (Autor:in) / Deng, Jun (Autor:in) / Li, Liguang (Autor:in) / Tong, Sunyu (Autor:in) / Li, Xianjing (Autor:in)

    Kongress:

    SAE/KSAE 2013 International Powertrains, Fuels & Lubricants Meeting ; 2013



    Erscheinungsdatum :

    2013-10-14




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Analysis of Mixture Formation of Direct Injection Gasoline Engine

    Saito, Kimitaka / Kano, Masao / Basaki, Masatoshi et al. | SAE Technical Papers | 1998


    Analysis of mixture formation of direct injection gasoline engine

    Kano,M. / Saito,K. / Basaki,M. et al. | Kraftfahrwesen | 1998



    Analysis of mixture formation of direct injection gasoline engine

    Kano,M. / Saito,K. / Basaki,M. et al. | Kraftfahrwesen | 1999