Many of the certification regulations in 14 CFR Part 25 are by design, broad and as such, can be subject to large differences in the interpretation of what constitutes adequate compliance. Advisory Circulars (AC's) were developed for many of the regulations to assist industry, as well as certification personnel, with what is considered an acceptable, but not the only means, of compliance. However, there are many regulations where no advisory material is available. In these cases, the “acceptable means” of compliance can vary to a greater degree among the various aircraft certification offices. This difficulty is aggravated as new applicants and regulatory personnel enter the certification field.Recent discussions and interpretations on the usage of an avionic unit's mean time between failure or MTBF for its detectable faults as the basic repair rate for undetected or latent faults, is a subject area where no significant advisory material exists. Therefore certification office interpretation as to “what is acceptable maintenance” in such a situation can vary significantly. This paper discusses the use of an avionic unit's MTBF for detected faults - plus an allowable repair time after a detected failure has occurred before the unit would need to be repaired - as the safety analysis failure exposure time for undetected faults and establishes a mathematical basis justifying its use.The presented analysis approach shows that using the unit's MTBF for detected faults - plus an allowable, but time limited operating period before repair is needed - as the basic repair rate for the undetected faults, is an acceptable means of maintaining undetectable failures of protective elements. In this operating scenario, the risk of system loss due to operating with latent failures in multiple units of the protective elements can be adequately controlled to the needed classification levels.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Usage of MTBF for Exposure Times of Undetected Faults in Safety Assessments


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Peterson, Eric M. (Autor:in) / Larsen, Hals (Autor:in)

    Kongress:

    Aerospace Technology Conference and Exposition ; 2007



    Erscheinungsdatum :

    2007-09-17




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Seal can improve MTBF

    Online Contents | 2011


    High-voltage power supply MTBF improvement

    Dunbar, W.G. | Tema Archiv | 1979




    APPLICATION OF MEAN TIME BETWEEN FAILURE (MTBF) MODELS FOR AUTONOMOUS VEHICLES

    OBORIL FABIAN / FABRIS SIMONE / SUSSMANN ALON et al. | Europäisches Patentamt | 2023

    Freier Zugriff