A large quantity of fuel is injected into the cold manifold of the engine to enable a quick start. A substantial part of this fuel gets deposited on the manifold walls leading to the formation of a fuel pool. Improper fuel vaporization during the engine cold start leads to the formation of a large amount of HC emissions. In the present investigation, a small flexible polyamide strip heater was placed at a specific location where the fuel impingement happens to enhance fuel vaporization in a 4-stroke motorcycle engine. The heater was turned on 20 seconds before the engine started. A temperature controller was used to maintain the heater at 323 K. The emission data for 180 seconds from the engine start was measured. Initial tests were carried out without the heater to establish the baseline emissions. Later, tests were carried out with the heater switched on and compared. The results showed a 32 % reduction in cumulative HC emissions with the use of the heater. Additionally, it was also observed that CO and CO2 emissions were reduced by 56 % and 14 % respectively due to reduced fuel consumption when the heater was used.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Cold Start HC Emission Reduction Using Targeted Fuel Heating


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    10TH SAE India International Mobility Conference ; 2022



    Erscheinungsdatum :

    2022-10-05




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    GDi Cold Start Emission Reduction with Heated Fuel

    Kabasin, Daniel / Haller, James / Kazour, Joseph et al. | SAE Technical Papers | 2016


    Cold start emission reduction by barrier discharge

    Lepperhoff,G. / Scharr,D. / Pischinger,S. et al. | Kraftfahrwesen | 2000


    Cold Start Emission Reduction by Barrier Discharge

    Scharr, D. / Trompeter, F.-J. / Lepperhoff, G. et al. | SAE Technical Papers | 2000


    Fuel Injection Strategies to Minimize Cold-Start HC Emission

    Brereton, Giles J. / Fischer, Henning C. | SAE Technical Papers | 1997