SAE J1939-73 defines the SAE J1939 messages to accomplish diagnostic services and identifies the diagnostic connector to be used for the vehicle service tool interface. Diagnostic messages (DMs) provide the utility needed when the vehicle is being repaired. Diagnostic messages are also used during vehicle operation by the networked electronic control modules to allow them to report diagnostic information and self-compensate as appropriate, based on information received. Diagnostic messages include services such as periodically broadcasting active diagnostic trouble codes, identifying operator diagnostic lamp status, reading or clearing diagnostic trouble codes, reading or writing control module memory, providing a security function, stopping/starting message broadcasts, reporting diagnostic readiness, monitoring engine parametric data, etc. California-, EPA-, or EU-regulated OBD requirements are satisfied with a subset of the specified connector and the defined messages. This document has been revised with the following changes: Additional diagnostic message and special instructions FMI. Additions to document for China IV non road and OBD MY2024 regulations. Correction of the MIL activation mode for WWH and EURO VI implementations.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Application Layer - Diagnostics


    Erscheinungsdatum :

    2022-08-05



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Application layer - diagnostics

    SAE International | TIBKAT | 2020


    Application Layer - Diagnostics

    SAE Technical Papers | 2006


    Application Layer - Diagnostics

    SAE Technical Papers | 2004


    Application Layer— Diagnostics

    SAE Technical Papers | 1998


    Application Layer - Diagnostics

    SAE Technical Papers | 2017