This paper is intended to provide a summary of the necessary adjustments required for road-representative open-jet wind tunnel measurements on automobiles. The open-jet wind tunnel provides accurate measurements, but they are made in a finite-sized jet that differs from the unconfined open-road conditions. Furthermore, measurements on a given automobile made in different open-jet wind tunnels disagree with each other, and with measurements in closed-wall wind tunnels that were corrected for the influences of their solid boundaries. There appears to be reticence at some company levels to making ‘corrections’ to open-jet measurements. Perhaps non-specialist managers think that the need for a ‘correction’ means an erroneous measurement. It does not! Any high-quality wind tunnel measurement is accurate, but it needs to be ‘calibrated’ to on-road conditions through an appropriate set of procedures. Closed-wall wind tunnels measure higher drag coefficients, in comparison with those in an unconstrained on-road flow. Open-jet wind tunnels frequently measure a lower value. The closed-wall adjustments lower the drag coefficient to the unconstrained value. Open-jet adjustments should also adjust the drag coefficient to the same unconstrained value. This paper explores the range of effects from the finite jet and elucidates the effectiveness of a two-measurement correction procedure. It is shown that not every data point must be measured twice, only a small selected subset. Since approximately 20% of tunnel occupancy is in the fan-on condition, then the additional cost of correct accurate on-road-equivalent data is low.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    The necessity for boundary corrections in a standard practice for the open-jet wind tunnel testing of automobiles




    Erscheinungsdatum :

    2017




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch



    Klassifikation :

    RVK:    ZO 4200: / ZO 4200
    BKL:    55.20 / 55.20 Straßenfahrzeugtechnik
    Lokalklassifikation TIB:    275/7025



    The necessity for boundary corrections in a standard practice for the open-jet wind tunnel testing of automobiles

    Cooper, Kevin R / Mercker, Edzard / Müller, Jürg | SAGE Publications | 2017


    Calculation of wind tunnel blower for testing automobiles

    Weinig, F. | Engineering Index Backfile | 1940


    Practical wind tunnel tests of automobiles

    Schirmer, M. | Engineering Index Backfile | 1935


    Use of Designed Experiments in Wind Tunnel Testing of Performance Automobiles

    Landman, D. / Simpson, J. / Hall, B. et al. | British Library Conference Proceedings | 2002


    Use of designed experiments in wind tunnel testing of performance automobiles

    Landman, D. / Simpson, J. / Hall, B. et al. | Tema Archiv | 2002