AbstractThis paper develops and models the compliant spar concept that allows the wingspan to be varied to provide roll control and enhance the operational performance for a medium altitude, long endurance (MALE) UAV. The wing semispan is split into morphing partitions and the concept may be incorporated in each partition; however, only the tip partition is considered here. The compliant spar is made of compliant joints arranged in series to allow the partition to be flexible under axial (spanwise) loads, but at the same time stiff enough to resist bending loads. Each compliant joint consists of two concentric overlapping AL 2024-T3 tubes joined together using elastomeric material. Under axial (spanwise) loading, the elastomeric material deforms in shear, allowing the overlapping distance between the tubes to vary and hence the length (in the spanwise direction) of the joint/spar to vary. High fidelity modeling of the concept is performed. Then, structural design optimization studies are performed to minimize the axial stiffness and the structural mass of the concept for various design constraints. The flexible skin and actuation system to be used are also addressed.
Span Morphing Using the Compliant Spar
Journal of aerospace engineering ; 28 , 4
2015
Aufsatz (Zeitschrift)
Englisch
Span Morphing Using the Compliant Spar
ASCE | 2014
|Variable Wing Span Using the Compliant Spar Concept
British Library Conference Proceedings | 2013
|Variable Wing Span Using the Compliant Spar Concept
AIAA | 2013
|