The low-speed aerodynamic performance characteristics of two advanced counterrotation pusher-propeller configurations with cruise design Mach numbers of 0.72 were investigated in the NASA Lewis 9- by 15-Foot Low-Speed Wind Tunnel. The tests were conducted at Mach number 0.20, which is representative of the aircraft take-off/landing flight regime. The investigation determined the effect of nonuniform inflow on the propeller performance characteristics for several blade angle settings and a range of rotational speeds. The inflow was varied by yawing the propeller model to angle-of-attack by as much as plus or minus 16 degrees and by installing on the counterrotation propeller test rig near the propeller rotors a model simulator of an aircraft engine support pylon and fuselage. The results of the investigation indicated that the low-speed performance of the counterrotation propeller configurations near the take-off target operating points were reasonable and were fairly insensitive to changes in model angle-of-attack without the aircraft pylon/fuselage simulators installed on the propeller test rig. When the aircraft pylon/fuselage simulators were installed, small changes in propeller performance were seen at zero angle-of-attack, but fairly large changes in total power coefficient and very large changes of aft-to-forward-rotor torque ratio were produced when the propeller model was taken to angle-of-attack. The propeller net efficiency, though, was fairly insensitive to any changes in the propeller flow field conditions near the take-off target operating points.
Low-Speed Wind Tunnel Performance of High-Speed Counterrotation Propellers at Angle-of-Attack
1989
47 pages
Report
Keine Angabe
Englisch
Aerodynamics , Test Facilities & Equipment , Angle of attack , Contrarotating propellers , Propeller blades , Propeller efficiency , Wind tunnel tests , Aerodynamic configurations , Counter rotation , Low speed wind tunnels , Mach number , Nonuniform flow , Performance tests , Prop-fan technology , Simulators