High-quality infrared focal plane arrays (FPAs) are used in many satellite, astronomical, and terrestrial applications. These applications require highly-sensitive, low-noise FPAs, and therefore do not benefit from advances made in low-cost thermal imagers where reducing cost and enabling high-temperature operation drive device development. Infrared detectors used in FPAs have been made for decades from alloys of mercury cadmium telluride (MCT). These infrared detectors are nearing the believed limit of their performance. This limit, known in the infrared detector community as Rule 07, dictates the dark current floor for MCT detectors, in their traditional architecture, for a given temperature and cutoff wavelength. To overcome the bounds imposed by Rule 07, many groups are working on detector compounds other than MCT. We focus on detectors employing III-V-based gallium-free In As Sb superlattice active regions while also changing the basic architecture of the pixel to improve signal-to-noise. Our architecture relies on a resonant, metallic, subwavelength nanoantenna patterned on the absorber surface, in combination with a Fabry-Perot cavity, to couple the incoming radiation into tightly confined modes near the nanoantenna. This confinement of the incident energy in a thin layer allows us to greatly reduce the volume of the absorbing layer to a fraction of the free-space wavelength, yielding a corresponding reduction in dark current from spontaneously generated electron-hole pairs in the absorber material. This architecture is detector material agnostic and could be applied to MCT detector structures as well, although we focus on using superlattice antimonide-based detector materials. This detector concept has been applied to both mid-wave (3–5 μm) and longwave (8–12 μm) infrared detectors and absorbers. Here we examine long-wave devices, as these detectors currently have a larger gap between desired device performance and that of currently existing detectors. The measured structures show an external quantum efficiency exceeding 50%. We present a comparison of the modeled and measured photoresponse of these detectors and compare these detectors to currently available commercial detectors using relevant metrics such as external quantum efficiency. We also discuss modeling of crosstalk between adjacent pixels and its influence on the potential for a dual-wavelength detector. Finally, we evaluate potential advances in these detectors that may occur in the near future.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Next-generation infrared focal plane arrays for high-responsivity low-noise applications


    Beteiligte:
    Goldflam, M. D. (Autor:in) / Hawkins, S. D. (Autor:in) / Parameswaran, S. (Autor:in) / Tauke-Pedretti, A. (Autor:in) / Warne, L. K. (Autor:in) / Peters, D. W. (Autor:in) / Campione, S. (Autor:in) / Coon, W. T. (Autor:in) / Keeler, G. A. (Autor:in) / Shaner, E. A. (Autor:in)


    Erscheinungsdatum :

    2017-03-01


    Format / Umfang :

    692582 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Next Generation IR Focal Plane Arrays and Applications

    Caulfield, J. | British Library Conference Proceedings | 2004


    High-Performance Infrared Focal Plane Arrays for Space Applications

    Sprafke, T. / Beletic, J.W. | British Library Online Contents | 2008


    Large Infrared Focal Plane Arrays for Space Applications

    Tribolet, P. / Chorier, P. | British Library Conference Proceedings | 2002