This paper describes work on a concept for a probe that would be capable of km-scale deep subsurface ice penetration on Europa or other Ocean World. Penetrating deep into or through the ice cap over the liquid ocean is the best way to establish if life has evolved there. A central thesis of this work is that we must start by addressing the Planetary Protection constraints, and not to try to add them on at the end. Specifically, all hardware in the probe would be designed to survive heat sterilization at 500C for extended periods, as required to meet the COSPAR 1-in-10,000 probability per mission of biological contamination of the ocean. The baseline concept features a heat source containing plutonium-238 encased within a stainless Dewar so that the heat is not lost by conduction into the ice. A circular saw blade sticks out through a slot in a hemispherical turret dome at the bottom of the Dewar such that the blade cuts the ice as it spins. The turret also rotates slowly to cause the saw blade to make a hemispherical cut in the ice. The ice chips would be thrown up through the slit into the turret and would be melted by the heat source. The meltwater drains into sumps on either side of the sawblade, from which the meltwater would be pumped out to the rear of the probe. The main body of the probe contains a spool of aluminum tubing that would be dispensed from within the probe all the way back to the lander. This tubing is nominally 1–3 mm in outside dimension with integral insulated electrical wires around the center hole. This tube would pneumatically transport small (mm-scale) single-use canisters containing meltwater samples from the probe to the surface for analysis. Surface analysis allows use of instruments that can be neither miniaturized nor sterilized sufficiently to go down-hole. Dry inert gas would be used to push the canister down from the lander and back up. The dry gas would be re-compressed and re-used. During a portion of the cruise to the outer solar system, the heat source would heat the entire probe, including the coiled tubing inside as well as all the canisters and inert gas, to 500C to destroy any lingering organisms and to decompose any complex organic molecules. The paper describes analysis, design, and preliminary testing, as well as plans for building a prototype and testing it in an “ice treadmill” where a plug of ice is created inside a vertical LN2 cold jacket, pushed up by water pumped below so that the ice plug rises at the same rate that the probe penetrates the ice.
A deep subsurface ice probe for Europa
2017-03-01
906325 byte
Aufsatz (Konferenz)
Elektronische Ressource
Englisch
Penetrators for in situ subsurface investigations of Europa
Online Contents | 2011
|Penetrators for in situ subsurface investigations of Europa
Elsevier | 2010
|