A 1:100-scale model of Port San Luis (formerly known as San Luis Obispo Harbor), California, and sufficient offshore area to permit generation of the required test waves, was used to investigate the arrangement and design of certain proposed harbor improvements with respect to wave action. The proposed harbor improvements consisted of (A.) an 1150-ft-long south breakwater extending east-northeast from Smith Island, with a 370-ft-long breakwater wing extending northward from this structure; (B.) a 3515-ft-long detached breakwater with a north-northeast to south-southwest alignment, located approximately 500 ft seaward of the Port San Luis Wharf; (C.) a 1300-ft-long north breakwater extending from a point on shore southward toward the north end of the detached breakwater; and (D.) development of the inner harbor by constructing landfill areas and boat slips for the anchorage of small pleasure craft. A 60-ft-long wave machine and electrical wave height measuring and recording apparatus were utilized in model operation. Base tests were conducted with existing prototype conditions installed in the model. Results of the tests involving the various improvement plans were compared with the base test results to determine the relative effectiveness of the respective plans. Of the plans tested, the optimum configuration appears to be that designated as Plan 12. It was concluded from the test results that (1.) the proposed 1300-ft-long north breakwater and the 370-ft-long south breakwater wing can be replaced by revetted fills; (2.) the length of the south breakwater should be increased by 400 ft; (3.) the northern end of the proposed harbor should be redesigned to prevent excessive wave heights in that area; (4.) the optimum harbor improvement plan (plan 12) will provide sufficient protection to the inner harbor from storm waves most of the time; however, when exceptionally high storm waves from the south-southeast deepwater direction occur simultaneously with high tide conditions, wave heights in the northern part of the harbor will reach magnitudes of approximately 3 ft; and (5.) installation of the proposed breakwater and other harbor structures will not adversely affect wave conditions at the Union Oil Company Pier.


    Zugriff

    Download


    Exportieren, teilen und zitieren



    Titel :

    Design for Expansion of Port San Luis, California: Hydraulic Model Investigation



    Erschienen in:

    Erscheinungsdatum :

    1969


    Format / Umfang :

    6446521


    Medientyp :

    Report


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Klassifikation :


    Expansion of Port Hueneme, California: Hydraulic Model Investigation

    Crosby, Leroy G. / Durham, Donald Lee / Chatham, Claude E. Jr. | HENRY – Bundesanstalt für Wasserbau (BAW) | 1975

    Freier Zugriff

    Wave and Surge Conditions after Proposed Expansion of Monterey Harbor, Monterey, California: Hydraulic Model Investigation

    Chatham, Claude E. Jr. | HENRY – Bundesanstalt für Wasserbau (BAW) | 1968

    Freier Zugriff

    Design of Proposed Crescent City Harbor, California, Tsunami Model: Hydraulic Model Investigation

    Senter, Paul K. | HENRY – Bundesanstalt für Wasserbau (BAW) | 1971

    Freier Zugriff

    Design for Small-Boat Harbor Improvements, Port Washington Harbor, Wisconsin: Hydraulic Model Investigation

    Bottin, Robert R. Jr. | HENRY – Bundesanstalt für Wasserbau (BAW) | 1977

    Freier Zugriff