When supplying power to a load (3) from a power supply (B) via a parallel circuit (5) of two electrical wires (51, 52) having the same wiring resistance, a vehicle power supply control device (1) uses a current measurement unit (b) in intelligent power devices (IPDs) (131, 132) to measure the passing current flowing in a semiconductor switching element (a) in each electrical wire (51, 52). Then, in order to match the temperatures of the electrical wires (51, 52) as estimated by a current temperature estimation unit (115a) on the basis of the measured current, a target duty ratio in a PWM control for reducing the passing current in the semiconductor switching element (a) of the IPD (131) on one electrical wire (51) is calculated in a target duty ratio calculation unit (115b), and the semiconductor switching element (a) of the one IPD (131) is turned on/off by a PWM/DC control and shutoff determination unit (112) with the calculated target duty ratio.

    La présente invention porte sur un dispositif de commande d'alimentation électrique de véhicule (1) qui utilise, lors de la fourniture d'énergie à une charge (3) à partir d'une alimentation électrique (B) par l'intermédiaire d'un circuit parallèle (5) composé de deux fils électriques (51, 52) ayant la même résistance de câblage, une unité de mesure de courant (b) présente dans des dispositifs de puissance intelligents (IPD) (131, 132) pour mesurer le courant circulant dans un élément de commutation à semi-conducteur (a) dans chaque fil électrique (51, 52). Ensuite, dans le but de faire concorder les températures des fils électriques (51, 52), estimées par une unité d'estimation de température actuelle (115a) sur la base du courant mesuré, un rapport cyclique cible dans une commande de modulation d'impulsions en durée (PWM) pour réduire le courant circulant dans l'élément de commutation à semi-conducteur (a) de l'IPD (131) présent sur un fil électrique (51) est calculé dans une unité de calcul de rapport cyclique cible (115b), et l'élément de commutation à semi-conducteur (a) dudit IPD (131) est mis à l'état passant/bloqué par une unité de commande PWM/DC et de détermination d'arrêt (112) avec le rapport cyclique cible calculé.

     車両用電源制御装置(1)は、配線抵抗が互いに等しい2つの電線(51,52)の並列回路(5)を介して電源(B)から負荷(3)に供給するのに当たり、各々の電線(51,52)上の半導体スイッチング素子(a)を流れる通過電流をIPD(131,132)の電流測定部(b)で測定する。そして、測定電流から現状温度推定部(115a)で推定した各々の電線(51,52)の温度を一致させるために、一方の電線(51)上のIPD(131)の半導体スイッチング素子(a)の通過電流を減らすPWM制御の目標デューティー比を目標デューティー比算出部(115b)で算出し、算出した目標デューティー比で一方のIPD(131)の半導体スイッチング素子(a)をPWM/DC制御及び遮断判定部(112)によりオン・オフさせる。


    Zugriff

    Download


    Exportieren, teilen und zitieren



    Titel :

    VEHICLE POWER SUPPLY CONTROL DEVICE


    Weitere Titelangaben:

    DISPOSITIF DE COMMANDE D'ALIMENTATION ÉLECTRIQUE DE VÉHICULE
    車両用電源制御装置


    Beteiligte:
    NAKAMURA YOSHIHIDE (Autor:in) / UETA KEISUKE (Autor:in) / IKUTA YOSHINORI (Autor:in) / SHIGEZANE YASUYUKI (Autor:in) / SATAKE SHUUJI (Autor:in)

    Erscheinungsdatum :

    2016-05-06


    Medientyp :

    Patent


    Format :

    Elektronische Ressource


    Sprache :

    Japanisch


    Klassifikation :

    IPC:    H02H EMERGENCY PROTECTIVE CIRCUIT ARRANGEMENTS , Schutzschaltungsanordnungen / B60Q ARRANGEMENT OF SIGNALLING OR LIGHTING DEVICES, THE MOUNTING OR SUPPORTING THEREOF OR CIRCUITS THEREFOR, FOR VEHICLES IN GENERAL , Anordnung von Signal- oder Beleuchtungsvorrichtungen, deren Einbau oder Halterung oder deren Schaltkreise bei Fahrzeugen allgemein / B60R Fahrzeuge, Fahrzeugausstattung oder Fahrzeugteile, soweit nicht anderweitig vorgesehen , VEHICLES, VEHICLE FITTINGS, OR VEHICLE PARTS, NOT OTHERWISE PROVIDED FOR / G01R Messen elektrischer Größen , MEASURING ELECTRIC VARIABLES



    VEHICLE POWER SUPPLY CONTROL DEVICE AND VEHICLE POWER SUPPLY DEVICE

    SUGISAWA YUUKI | Europäisches Patentamt | 2020

    Freier Zugriff

    VEHICLE POWER SUPPLY CONTROL METHOD AND VEHICLE POWER SUPPLY CONTROL DEVICE

    KOISHI AKIFUMI / TAHARA MASAHIKO / TEZUKA ATSUSHI et al. | Europäisches Patentamt | 2022

    Freier Zugriff

    VEHICLE POWER SUPPLY CONTROL METHOD AND VEHICLE POWER SUPPLY CONTROL DEVICE

    KOISHI AKIFUMI / TAHARA MASAHIKO / TEZUKA ATSUSHI et al. | Europäisches Patentamt | 2021

    Freier Zugriff

    Vehicle power supply control method and vehicle power supply control device

    KOISHI AKIFUMI / TAHARA MASAHIKO / TEZUKA ATSUSHI et al. | Europäisches Patentamt | 2020

    Freier Zugriff

    Vehicle power supply control method and vehicle power supply control device

    KOISHI AKIFUMI / TAHARA MASAHIKO / TEZUKA ATSUSHI et al. | Europäisches Patentamt | 2023

    Freier Zugriff