The purpose of this paper is to produce and investigate a reliable and effective aircraft brake lining material.

    Design/methodology/approach

    In total, four different Cu-based brake lining samples were produced by powder metallurgy. The produced samples were tested in an experimental setup on friction, wear and mechanical performance, then metallographic and scanning electron microscope inspections were performed. Hardness, compression strength and density of copper-based brake linings were also tested. Moreover, a numerical simulation of the structural reaction of a sample under compression was carried out by using ANSYS.

    Findings

    According to tests, suitable aircraft brake lining material composition would be 75% Cu, 5% Fe, 5% Sn, 5% Graphite, 5% SiO2, 5% MoS2.

    Practical implications

    The paper will help designers choose the most proper ingredient combination for aircraft brake lining materials.

    Originality/value

    The paper notes that adding silicon dioxide and graphite forms a porosive structure. In addition, porosity brings a low strength and high wear rate.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Friction and wear behaviors of aircraft brake linings material


    Beteiligte:
    Çeliktaş, Erhan (Autor:in) / Topuz, Ahmet (Autor:in) / Kazancı, Zafer (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2012-08-31


    Format / Umfang :

    8 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch





    FORECASTING WEAR OF BRAKE LININGS

    PREHOFER BORIS ANDRE | Europäisches Patentamt | 2018

    Freier Zugriff

    The Brake Rotor - Friction Partner of Brake Linings

    Metzler, Horst | SAE Technical Papers | 1990


    Coefficient of friction of brake linings

    Abadie, M. | Engineering Index Backfile | 1926


    Friction and wear of brake linings with regard to bedding procedure

    Duboka,C. / Arsenic,Z. / Faculty of Mechanical Engineering Belgrade,YU | Kraftfahrwesen | 1986