This work was performed within IMI Spray Mould, an EPSRC joint funded programme, aimed at developing a manufacturing route for large aerospace composite forming tooling, based on metal spray technologies. Assesses the mechanical properties of Invar steel coatings, deposited using electric arc spraying, and correlates these properties to the spray parameters and processes used so as to offer coatings with characteristics appropriate to the tooling requirements. In particular, two processing methods, inert and air atomisation, and three arc spray gun configurations (air cap design) are evaluated. The mechanical properties of the coatings are found to be low compared to bulk Invar, regardless of the spray parameters and hardware used. Inert arc spraying affords more consistent coating characteristics but this comes with a compromised durability. The spray hardware is found to be more significant in determining the coating properties than the parameters employed.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Metal spray Invar tooling for composites


    Beteiligte:

    Erschienen in:

    Erscheinungsdatum :

    2000-10-01


    Format / Umfang :

    10 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Contributed papers - Metal spray Invar tooling for composites

    Wimpenny, David Ian | Online Contents | 2000


    Rapid tooling using metal spray methods

    Dunlop,R.N. / Univ.of Warwick,GB | Kraftfahrwesen | 1995


    Rapid Tooling using Metal Spray Methods

    Dunlop, R. N. | British Library Conference Proceedings | 1995


    Spray-formed tooling

    McHugh,K.M. / Key,J.F. / Idaho National Engng.Lab.,US | Kraftfahrwesen | 1995


    Spray-Formed Tooling

    McHugh, K. M. / Key, J. F. / SAE et al. | British Library Conference Proceedings | 1995